if your usb/pendrive not working properly its displayed an error message your device is not supported and formatted or its corrupted at that time we cannot do any thing at that we can do one thing to repair our pen/usb drive follow the bellow steps to over come the problem:
1.First insert Memory Card/USB Hard Drive with your computer through your USB port and remove all other drives if you have connected.
11.Now enter the command select partition 1.
12.Now type format fs=fat32 and press enter.
13.Thats it it will take some time and after that your drive will get successfully format and become ready to use
14.if you want ntfs format repeat all step1
to step 11
15.in the place of step12 place format fs=ntfs and
press enter
16.now type assign its done
1.First insert Memory Card/USB Hard Drive with your computer through your USB port and remove all other drives if you have connected.
2.Now open my computer and note down the drive letter of your USB or memory
card.
3.Now click on start and then type cmd and
then press enter or type cmd on search bar right click run as
administrator.
4.Now type DISKPART in command prompt and popup might appears asking for
permission,click ok
5.Now type list disk there and you will see
all the disk will get listed there.
6.Now there you will see your external drive, note down its
disk number.
7.Now type select disk disk_number and press enter.
8.Now type clean and press enter.
9.Now type create partition primary and then press enter.
10.Now type active and press enter.7.Now type select disk disk_number and press enter.
8.Now type clean and press enter.
9.Now type create partition primary and then press enter.
11.Now enter the command select partition 1.
12.Now type format fs=fat32 and press enter.
13.Thats it it will take some time and after that your drive will get successfully format and become ready to use
14.if you want ntfs format repeat all step1
to step 11
15.in the place of step12 place format fs=ntfs and
press enter
16.now type assign its done
No comments:
Post a Comment